|Descripción | Description|
|Motec rFactor 2 Plugin Version:1.05|
Nota del autor: Porfavor, leer el texto incluido en el archivo readme.txt.
Installation: Extract the entire archive to your main rFactor 2 folder. If done correctly you'll have the MotecPlugin.dll sitting beside the NetCommUtilPlugin.dll that comes with rF2. If not, do it again.
If correctly installed, when you run rF2 the plugin will create a new LOG folder to store the logs, a MotecPlugin.ini file for setting various options, and by default will log the default channels at the standard rates.
To change the options quit out of rF2, find the MotecPlugin.ini file which should be in your main rF2 folder*, and check out the available settings.
By default logging is active on startup, which means all your driving will be logged. When you jump into a car you'll hear beeps indicating the current logging status:
'Upwards beeps' = logging on. 'Downwards beeps' = logging off.
To toggle between logging on & off, hit Ctrl-M (or your own defined key) while in the car.
Note: In the current version of rF2 a red plugin icon appears when you jump in the car; this is normal and doesn't mean anything has gone wrong. However, plugins are not active until this icon disappears again (~20 secs or so), so if you have logging active you won't get logged data for this period, and if you try to switch it on you won't be able to until the icon disappears.
When logging is finished, either through switching it off or by exiting the car, you will hear the beeps indicating the log has finished being built (converted from the temp file) usually after a short pause. You can then open it up in i2Pro as you wish.
If you log a lot of data then try to immediately exit rF2, it might pause on a blackscreen for a short period. A driving stint of several hours should only take 5-10s to finish converting. (longer stints or higher data rates will take longer)
- Found a bug causing a freeze/crash when exiting the car immediately after setting a time. Shouldn't cause a crash anymore, but be aware the laptime still won't work properly (best to bring the car to a stop or even drive back around to the pits before Escaping)
- Fixed a bug that was causing corrupted LOG paths and game slowdowns.
Always, if upgrading from an older version it won't rewrite the existing MotecPlugin.ini - so you need to rename it or delete it, then start up rF2, to see any new .ini options.
Presentación / instrucciones oficiales extraidos del post oficial del autor.
|Imágenes | Screenshots|
|Anuncio | Advertisment|
|Descargas | Downloads|
|Changed at||2016-01-04 23:40:41|